Volvo RWD 444-544 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2009 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Where to brace body whilst repairing rockers/frame rails? 444-544

posted by  someone claiming to be Rockmonton on  Thu Nov 19 17:17 CST 2009 [RELATED]

Hey guys, gotta do the big cut now to start repairing the unibody on the 1959/60' that means cutting out some structural bits. I've got a whack of 3 and 4" square tubing that i'm intending to use to brace up the body. I'm just trying to figure out where to put it.

I'm thinking right now, between the A pillars where the dash was, between the B pillars and then a brace between them and to the large hump behind the front seats.

any suggestions/tips/tricks? I'm fairly certain i'll be rebuilding the inner structure of the rocker panel too, so it will have to last a while like this. I will also add in the 3/16" Plate for a roll cage and for my suspension mounts as well.

May have a line on the 540i rear end now too!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Where to brace body whilst repairing rockers/frame rails? [444-544]
posted by  someone claiming to be Rockmonton  on Thu Nov 19 17:17 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.