Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

M46 - Speedo Retaining Bolt Threads Stripped 200

posted by  AppleTech on  Sun Nov 8 16:32 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Nov 13 14:40 CST 2011
[RELATED]

The threads for the hole where the speedo retaining bolt goes are stripped - someone installed the incorrect bolt at some point :( I have no away to hold in my speedo gear.

Should I drill and tap or use a helicoil? I'm not familiar with aluminum so I don't know which works better. Does anyone have any advice on how to fix this? I know the hole is supposed to be M6 x 20MM, but I can't find any helicoils that long without going up to M10, which means the retaining clip won't fit (I don't think I could even drill it that big either).

Thanks in advance for your advice...

-Phil






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 - Speedo Retaining Bolt Threads Stripped [200]
posted by  AppleTech  on Sun Nov 8 16:32 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.