Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2005 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

water pump return line nut is rounded – can't remove 900 1994

posted by  lovemy940s on  Thu Oct 22 07:53 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Nov 13 03:11 CST 2010
[RELATED]

I'm really stuck. Bought a '94 940 that's been butchered by at least one mechanic.

Need to replace a mashed up mushroom gasket that's causing a coolant leak. The nut holding the return line to the back of the water pump is rounded. Really rounded. Won't budge.

There's no room to maneuver vise grips. A nut buster won't fit either. I'm thinking of cutting the nut off with my Dremel. Maybe the whole stud.

So is there a tool I can use I'm unaware off? Perhaps a secret technique for removing the nut? And if I get really desperate and lob off the stud, what surprises am I in for when I pull the pump off? Is the stud attached to the back of the water pump? Is it easily replaced?

Thanks so much!

Roger






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New water pump return line nut is rounded – can't remove [900][1994]
posted by  lovemy940s  on Thu Oct 22 07:53 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.