Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Strut tube removal- best way to deal with the ABS sensor? 700 1988

posted by  rstarkie on  Sun Aug 16 07:48 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

1988 744t M46od 199k

Having replaced the rear shocks I want to move on to replacing the strut inserts.

I was glad to see the brake line supports are not part of the strut tube (as in the 240’s) so I plan to simply take the caliper loose and hang it in the fender well.

This car is equipped with ABS and I am wondering if the safest way to deal with the sensors is to disconnect the wire in the engine compartment and leave the sensors and wires attached to the strut assembly?

Thanks for your help.

Randy





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Strut tube removal- best way to deal with the ABS sensor? [700][1988]
posted by  rstarkie subscriber  on Sun Aug 16 07:48 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.