Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Brake light switch 200 1990

posted by  scott87 on  Mon Jul 27 00:33 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Dec 11 12:48 CST 2011
[RELATED]

I replaced the rear brake light switch (tough job but made easier with help from brickboard). When I reconnected the instrument panel my check engine light is on and the engine idles high. Engine will constantly rev high then low. If I remove the largest connector on instrument panel (black round connector) engine will run normally but I have no instrument panel light, temp gauge, turn signals work but don't display on instrument panel...Good news is my brake lights now work.

Any suggestions as to what could be causing this problem?

1990 240/dl wgn.

Regards,

Scott






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake light switch [200][1990]
posted by  scott87  on Mon Jul 27 00:33 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.