Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2020

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to apply Heat Sink to power stage / ignition amplifier

posted by  NewMexico240 on  Mon Jun 15 11:08 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:52 CST 2014
[RELATED]

My 91 240 stalls in hot weather and I have read that it may be the
power stage / ignition amplifier needing HEAT SINK COMPOUND.

While at the salvage yard I pulled a power stage / ignition amplifier
and while removing the back metal plate the 'computer' chip pulled off
with the metal plate. There was clear paste/gel surrounding the
'computer chip'.

How do I apply Heat Sink Compound on/in my power stage / ignition amplifier
without pulling off the 'computer chip'?

Thanks,
Joseph






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to apply Heat Sink to power stage / ignition amplifier
posted by  NewMexico240 subscriber  on Mon Jun 15 11:08 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.