Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Complete removal of the intake manifold 200 1989

posted by  CineMan on  Thu May 7 16:01 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 15:21 CST 2014
[RELATED]

Hello,

I don't just want to replace my intake manifold gasket, I want to pull the whole sucker out and scrub its insides clean. Obviously I disconnect all the bolts and the air hose and/or throttle body. But I have no clue when it comes to the fuel delivery system. Can I disconnect the fuel line from the fuel rail? What is the best way to completely disconnect everything so I can pull the whole thing out?

Yes, I am also planning to change my coolant temp sensor, temp gauge sensor and heater hoses, as well as cleaning out the oil trap "while I am in there" (already did the IAC and TB). Also, I have a new original style heater control valve from IPD, but I am confused as to exactly where that is located. Is that what sticks through the firewall that the heater hoses connect to, or are there other hoses inside the cabin that run from the firewall to the control valve?

Thanks!

Ryan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Complete removal of the intake manifold [200][1989]
posted by  CineMan  on Thu May 7 16:01 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.