Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2016 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

M46 stuck in OD, replaced O-rings, still stuck 700 1988

posted by  zrubin on  Tue May 5 05:16 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 20 15:45 CST 2012
[RELATED]

My 1988 740 Turbo with M46 shifts out of overdrive when the button is pushed if it has only been in OD a few minutes. But when I drive 30 miles to work, then push the button, the OD light turns off but the OD stays engaged. On cold days, after 20 seconds or so of driving after pushing the button the OD would then disengage by itself. Now it's warmer out and the OD still hasn't disengaged after driving a couple miles in 1st/2nd/3rd. I read the FAQ and concluded the solenoid needed new O-rings, had them replaced at the local independent Volvo shop. This did not solve the issue. What next? Replace the solenoid? Change the fluid? Disassemble and clean the solenoid plunger?

Zack
1980 245DL M46 293k
1988 745T+ M46 240k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M46 stuck in OD, replaced O-rings, still stuck [700][1988]
posted by  zrubin  on Tue May 5 05:16 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.