Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

adding a fill port on the ac 200

posted by  Nel621 on  Sat Apr 25 15:14 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 12:48 CST 2014
[RELATED]

I have an 87 240 with 134a in it.I would like to add a fill port to the top hose that crosses over the engine.I believe this is the low side.I went to a place that can make hoses with the compressed fittings.He said to bring mine in and he would do the conversion.But this hose is a pain the neck to remove and he doeen't have small portable crimper.So can i add this fill port and just connect it in line with hose clamps?It is the low side so I think it would be ok pressure wise,yes?Your thoughts on this.I have seen a few cars with this conversion/adaptation.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New adding a fill port on the ac [200]
posted by  Nel621 subscriber  on Sat Apr 25 15:14 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.