Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

stubborn 312, 213,221, 113 fault codes 200 1989

buy used '89 240 with 235.000 miles. check engine light on, runs rich, o2 stuck on .9 volt
pull fuel codes ( no ignition codes 1-1-1) # 312 missing anti-knock sensor signal, #213 throttle switch, #221 fuel system compensating for rich/lean fuel mix, #113 injector fault.
replaced o2 with new bosch , now switches voltage.
replaced knock sensor with used from pick and pull, test/measures .07 volts at pin 28 @ ECU conn.
do I need to try a NEW knock sensor if signal is still missing ??
will double check for more vacuum leaks. I have only driven car a short distance since repairs were made. Car seem to run ok and has lots of power but the dam CEL comes on after 3 miles with the above codes.
I did have to gut the CAT though, as it was starting to break apart inside and I don't believe this has any effect on the o2.(ahead of CAT)
I'm not to concerned with #213 or #113 for now.
any suggestions ?? Thanks
peter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New stubborn 312, 213,221, 113 fault codes [200][1989]
posted by  vesparally  on Mon Mar 30 16:09 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.