Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1 2 3 Fault in signal to/from coooant temperature sensor 200 1992

posted by  dbristor on  Wed Mar 11 13:03 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 28 08:54 CST 2009
[RELATED]

Fault in signal to/from coolant temperature sensor

Replaced sensor (Bosch number 0 280 130 026)
replaced connector to sensor
replaced ECU 0 280 000 561 with 0 280 000 591
The resistance from pin 13 on the ECU conector to pin 2 on the IG module is 2,715 at 70 degrees F. and drops down to approximately 284 ohms at operating temperature.

I still have a check engine light ( which can be cleared however returns with in a few minutes with the 1 2 3 code).

I did not replace the Ing. module 0 227 400 169

Any assistance would be greatly appreciated

Thanks

Dave





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 2 3 Fault in signal to/from coooant temperature sensor [200][1992]
posted by  dbristor  on Wed Mar 11 13:03 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.