Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

960 Control Arms 900 1996

posted by  dubs960 on  Fri Aug 8 21:40 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 28 07:00 CST 2008
[RELATED]

Ok, I didnt want to buy new OEM lower control arms so I bought OEM bushings. I did a fair job with the r&r but wonder if it was worth it now. The bushings were a PITA to get in/out without the "proper" Volvo tool & later asked myself how much the tool cost vs. the agony ! The "rear" (plastic/rubber) wasnt that hard, the "front" was the pita ! I couldnt get the control arm to sit in my shop press correctly for the front bushing so I created a jig (.875 from the machined face of the control arm to the end of the inner bolt sleeve) and using trickory (Heat & Ice) I got it to within reason (+/-.010)
The main reason for doing it this way was to save some $$ & not have to buy a Volvo lower control arm or a spinoff like scan tech, etc. but let it be known, it may be worth buying the tool if you like to DIY and keep a fleet of Volvos in stock !

Vovlo for Life Right ?

Anyone have a P/N and/or price of the tool ?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 Control Arms [900][1996]
posted by  dubs960  on Fri Aug 8 21:40 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.