Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2010 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oil leaking badly after oil filter adaptor black seal replacement 900 1995

posted by  Anatoli on  Fri Aug 1 05:40 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Nov 4 21:52 CST 2013
[RELATED]

I was replacing seals on oil return line from turbo, distributor seals, oil filter adaptor seal. It all went well, other that it took me awhile.

Today I fill the car with oil and started it and immediately there's a lot of leaking like almost pouring from the oil cooler areal where I put in the black seal.

I was wondering if i tightened it enough or what else could be the problem.
I put it onto a little bit of silicone grease between two flat surfaces on the oil adapter and on the oil cooler. Then I tightened it as well as I could with and adjustable wrench. I admit i might have not done a good job with tightening it well enough, but this much leaking its awful.

Did i do it right, as far as placing the seal. I did not find any groove to put it in.

thanks a buch

car is 95 944T auto with 129K miles on it.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil leaking badly after oil filter adaptor black seal replacement [900][1995]
posted by  Anatoli  on Fri Aug 1 05:40 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.