Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Plug wire resistance value range needed for a B23F 200

posted by  volvo245kit on  Fri Jul 11 14:21 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 30 20:54 CST 2011
[RELATED]

Hello, Heres the deal. I'm still trying to find out why my project car is running rough. I've swapped out the coil & checked (and rechecked) the plug wires

are installed correctly. I have a new set of Magnecor wires on it and a new set of NGK iridium tipped plugs as well so I thought about checking the wire

resistance. I've been told that there's an acceptable range for this. I looked through both the Bentley and the Haynes manuals and I can't find this spec

anywhere. Does anyone know what the resistance is supposed to be? Here are the readings I have. They are (reading from front to back looking down the engine

block)#1)4.30 ohms, #2)4.44 ohms, #3)5.17 ohms, #4) 5.01 ohms. Are these okay? Thanks, Charles (BTW, I also have a new Bosch cap, rotor and hall sensor

installed too.)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Plug wire resistance value range needed for a B23F [200]
posted by  volvo245kit  on Fri Jul 11 14:21 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.