Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Drive train vibration 200

posted by  bthompso on  Sun May 4 13:32 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Nov 6 19:05 CST 2011
[RELATED]

Hello all-

Some time ago there were several threads on drive train vibration in 240s. I'm not sure if this has been addressed recently, but I thought I'd toss my problem into the group:

With my '93 240 wagon (5sp) I have a droning, deep vibration between 45 - 60 mph, worst under load, a little lighter when no throttle. I've eliminated the following (by replacing): U-joints, center bearing plus rubber support, transmission mount, torque rod bushings. Also, wheels recently balanced, fluid check ok in trans and differential, brakes not dragging/pulsing or showing evidence of high heat. Vibe is independent of engine revs and only in this speed range. There was some talk on this list of shimming the center bearing support, which my mechanic pooh-poohed. But has anyone had a similar problem and a definitive solution?









THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Drive train vibration [200]
posted by  bthompso  on Sun May 4 13:32 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.