Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Control arm bushing installation question... 200 1989

uid 43101's pic
posted by  245DogWaggin on  Wed Apr 2 16:01 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 12 17:07 CST 2013
[RELATED]

Sandblasted, zinc phosphated and first coat of POR-15 is on. Getting close to installing the front position and rear position bushings in the refurbed control arms on my 245 and I was wondering: is there anything I should do to make the pressing a little easier such as a slight film of oil, teflon spray, grease, etc on the outer metal shells that might also act a bit as (minor) rust inhibitor?
And what's not good to get on the new rubber bushings?

--
89 245 'loaded' with a Great Pyrenees






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control arm bushing installation question... [200][1989]
posted by  245DogWaggin  on Wed Apr 2 16:01 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.