Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

No heat after new WP, thermostat, hoses, radiator flush. 200 1993

posted by  someone claiming to be jpistos on  Sun Mar 30 00:04 CST 2008 [RELATED]

OK little mystery here: Whilst changing the timing belt, I also put on a new water pump, changed radiator hoses, heater hoses (that was fun), put in a new thermostat. So then I flushed the radiator, like the directions say on the flush: "Run car to normal operating temp, put heater on high, run for 10 more minutes.." But there was no heat coming out the vents. I checked the radiator hoses - they were hot and full of water, the supply heater hose was also hot.
Any ideas? Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New No heat after new WP, thermostat, hoses, radiator flush. [200][1993]
posted by  someone claiming to be jpistos  on Sun Mar 30 00:04 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.