Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Exhaust Manifold to Header Studs 200 1993

posted by  Oleseahorse on  Thu Nov 29 03:32 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:45 CST 2014
[RELATED]

Hello All,

In replacing my downpipe, two of the three exhaust manifold to downpipe studs came out along with the attached copper nuts.

What is the best way for these two studs to be firmly installed into the manifold so they don't come out?

I don't think there's enough room to use doubled nuts on the studs for insertion as I recall there's not enough room to deal with inserting an open end wrench into the space.

I have red and blue locktite. Would that work?

If I crank a doubled nut with my socket, when I try to get nut no 1 off, I'm certain I'll pull the stud out again cause nut no 1 and nut no 2 won't easily separate.

Any suggestions as I'm sure lots of you have BTDT.

Thanks much,

Marty Wolfson
--
93, 244 141k, 93 244 - 235K (Injured awaiting repair), 93 245 - 172K, 99 v-70 - 112K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Exhaust Manifold to Header Studs [200][1993]
posted by  Oleseahorse subscriber  on Thu Nov 29 03:32 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.