Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wiring Power Window Regulators 200 1988

posted by  Stormie on  Fri Jun 29 18:24 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Nov 4 14:12 CST 2013
[RELATED]

Greetings,

Snagged four good motors for $15.00 each and I have switches + relay from my old '89 765TI. I bench tested the motors with the 760 switches and they work.

I want to put window switches in the center console and nothing on the doors, so they will only be controlled by the center console switches. One switch per regulator.

My 240 is a 4-door. I would like to wire the passenger side and then the drivers side in parallel, then run them to the center console switches. Power would be run from fuse #10 to the two sides for motors.

Can I run a single wire for power to all 4 motors and link the power to all switches at the center console?
Can I run all ground wires together per side and ground at two locations?
How is the relay wired in?

I appreciate any hot tips and assistance.

Stormie - '88 240DL 536,000 original miles, original owner, original engine and second tranny. Full poly bushings, HD Bils, TME Springs, IPD Sways, IPD Adj. panhard and Torque Rods. Upper + Lower chassis braces. dual power mirrors, E Fan and alot more in the works!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wiring Power Window Regulators [200][1988]
posted by  Stormie  on Fri Jun 29 18:24 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.