Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

IPD Polys in - popping sound when turning wheel 200

posted by  DHartlein on  Tue Mar 27 12:49 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 2 20:00 CST 2014
[RELATED]

Just put IPD poly bushings in the front and rear on my 91 240. Have the cherry turbo brace, strut tower to firewall braces, and the lower tie braces on.

After three days of smooth riding, I am getting a "popping" sound in the wheel/front suspension area when moving the steering back and forth slightly at 20 mph or so. Retorqued all bolts tied to the bushing install - all was fine - but could not check the pocket bushing before it got dark. Will do it tomorrow. Able to check the crossmember bolts from inside the engine compartment - all was well.

The ball joints are Boge with only 30K or so on them. The struts were replaced 35,000 miles ago.

Any ideas?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New IPD Polys in - popping sound when turning wheel [200]
posted by  DHartlein  on Tue Mar 27 12:49 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.