Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Hood insulation 200 1984

posted by  LeChuck on  Fri Mar 16 03:42 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Nov 27 10:21 CST 2013
[RELATED]

Hi folks,

While soundproofing my car I used a Dynamat clone called eDead. On top of that in the foot wells, inside the rear doors and in other places I used a product called Thermwell Duct Insulation that is sold at HomeDepot for about $15 per roll. I like that product. It is made of some relatively thick (in comparison to Dynamat) foam rubber with an auto-adhesive side and foil backing on the other side. It is made to wrap around ducts and quiet them down as well as provide some heat insulation.

I was wondering if anyone knows that product and if that type of stuff could withstand enough heat and be safely used as under-hood insulation. I have a bit of that left.

Thanks!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hood insulation [200][1984]
posted by  LeChuck  on Fri Mar 16 03:42 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.