Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Problem with vacuum bleeding brakes 200

posted by  FiremanBob on  Wed Jan 24 01:15 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Feb 2 10:30 CST 2009
[RELATED]

Yesterday I started bleeding the brakes with my Mity-Vac but ran into a problem that I think indicates an air leak in the system. Working at the left rear wheel I pumped out 200ml of dirty fluid and a lot of bubbles, and then sucked only air - no fluid, no bubbles, and the fluid level in the master cylinder reservoir did not fall.

The previous owner said that the brakes had been done only a few months ago, but the fluid was the color of molasses and the brake failure light is on unless I pump the brakes a few times.

Am I right in thinking this is a leak? Is it most likely to be in the master cylinder or in the hoses? What is the best way to trace it?

Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Problem with vacuum bleeding brakes [200]
posted by  FiremanBob  on Wed Jan 24 01:15 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.