Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Line installation for New Fuel Tank Sending Unit '90 200 1990

posted by  instantcrow on  Thu Nov 2 13:43 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Nov 27 05:55 CST 2008
[RELATED]

I'm planning on installing a new fuel tank sending unit (with a new in tank pump, gasket, lock ring, etc) this weekend. My prepump is dead, and everything is totally rusted (16 years in MA and Jersey). I'm pretty sure that I can just buy new low pressure line to replace the line between the tank and the main pump. What is the best way to reconnect the high pressure fuel return line to the sending unit? I don't want to replace the entire fuel return line (this is the line that returns gas from the fuel rail...I believe it's still around 40 PSI). I believe this line has a plastic inner core. Any suggestions or ideas would be much appreciated.

-instant






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Line installation for New Fuel Tank Sending Unit '90 [200][1990]
posted by  instantcrow  on Thu Nov 2 13:43 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.