Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2021 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Poly TAB installation 200 1988

posted by  macs70GLT on  Sun Oct 15 03:41 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 2 07:33 CST 2010
[RELATED]

I have the Poly trailing arm bushings for my 240 wagon, and the IPD removal tool.

One question, does the chamfered outside diameter of the outer sleeve go to the differential side or wheel side of the brackets?

I have not had anything apart yet, but know that one end of the outter sleeve does have this chamfer. I also noticed a chamfer on one of the bushing halves which fits in the chamfered end of the sleeve. I read through the small page of instructions but it was not clear to me.

Any other tips are also welcome. I have done some bushing work (torque rods) but appreciate the advice of those who have done the work.

Thanks

Mike
--
1988 245, 240K mi, 5 speed






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Poly TAB installation [200][1988]
posted by  macs70GLT  on Sun Oct 15 03:41 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.