Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

replace studs in exhaust manifold 700 1991

posted by  Liambean on  Wed Aug 23 16:14 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 4 12:34 CST 2013
[RELATED]

I understand that it is a given, these guys will get leaks between the exhaust manifold and the exhaust pipe
just replaced the gasket and yet I feel the air
and get that pfff pfff pfff
it drives me nuts
I understand the only way to properly solve the problem is to repalce the studs on the manifold
any thoughts?
any tricks?
I hesitate, what if a stud breaks yikes
I believe they should be solid, does one need a stud remover?

I have no torches, was thinking of putting it intothe oven, then dip the studs in cool water
good idea, very bad????





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New replace studs in exhaust manifold [700][1991]
posted by  Liambean  on Wed Aug 23 16:14 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.