Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Turbo Gauge Cluster Install 200 1992

posted by  Lanval on  Sat Mar 11 20:07 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon May 16 18:04 CST 2011
[RELATED]



Greetings all,

I've recently acquired a 3 gauge cluster (from a Turbo, I'm assuming, and thank you very much, Ebay) and have been reading the associated previous comments - so I've got a handle (maybe) on installing the voltmeter and oil pressure gauge. I'm wondering though, about the wiring harness - I take it that the later models aren't prewired for this harness (whereas the tach is - or should be prewired)? Can I acquire and fit a harness to the B230F engine to mate with this? Or is that more work than just individually wiring the volt/oilpress gauges?

Thanks,

Lanval






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Turbo Gauge Cluster Install [200][1992]
posted by  Lanval subscriber  on Sat Mar 11 20:07 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.