Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What is it with this 240 mufflers ? 200 1989

When I got the car at 155K miles three years ago, I put new mufflers and pipes from the cat back.

Two years later I had to replace the back muffler, it broke at the welding where the axle pipe attaches. The muffler (Bosal I believe) being under warranty I got a new one, got the 2 year old S tail pipe out from the 2 year 'old' Bosal and put all this back in.

Now one year later the 'new' Bosal muffler broke too, this time at the welding where there is a small bracket for the rubber hanger right before the S pipe.

Last time I did replace the Bosal myself, using a Hax saw and I paid a muffler shop a few dollars to remove the S pipe with a torch.

Why are these mufflers so weak? My engine does move a bit when I start the car, and rocks somewhat at iddle, but shouldn't the rubber hanger take that stress? And not the welding of the muffler...

--
'89 244DL M47 171K miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What is it with this 240 mufflers ? [200][1989]
posted by  guYom  on Sat Mar 4 13:50 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.