Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Timing belt procedure question 200 1986

posted by  Xraybob on  Wed Feb 1 05:24 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

Hello to all. I'm all set to replace my timing belt for the first time and notice one thing in my notes. When it comes time to secure the rotation when removing loosening the center bolt by using a large screwdriver in the ring gear. The warning said not to do this procedure on LH2.4 or any car with a crankshaft sensor as this will cause damage. From what I read in my Bentley Manual says I have a LH2.2, but doesn't say anything if I have a crankshaft sensor. Do I?

Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Timing belt procedure question [200][1986]
posted by  Xraybob  on Wed Feb 1 05:24 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.