Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

91 240 brake lights 200 1991

I have a question(s) about my 91 244DL. My question is about the rear brake light on the passenger side. I have had 2 pc boards "fry" the connection to that light on the board itself. I replaced the bulb failure sensor, the brake light switch is OK, bulbs are OK, bulb holders cleaned and checked, grounds were cleaned, and I tried different brands of bulbs. The center and driver side brake lights work fine. I have come to the conclusion that I want to "hard" wire from the connectors and eliminate the PC Boards. Any suggestions or guidance would be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 91 240 brake lights [200][1991]
posted by  VolvonutinPA  on Fri Jan 27 05:51 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.