Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

One last bilstein question (well, maybe two . . .)

posted by  anderssj on  Tue Jan 10 11:16 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 17:03 CST 2014
[RELATED]

Hi all,

First, thanks to all for the advice so far. It's been a big help. Bilsteins (and wrench) arrived today--they'll go in on Thursday.

I'm getting conflicting guidance on whether to use the Volvo spacer rings (PN 1229423). The car is currently equipped with OEM twin tube shocks and struts, so I guess it should already have the spacer rings too.

Site where I purchased the shocks doesn't say anything about removing the rings, FPC site also implies that the rings are used (that they're needed for GLTs that had gas struts). However, the Bilstein application table says "100 -If equipped with original twin tube, spacer ring in base of housing must be removed." So, the question is, with the Bilstein HDs, do I use the spacer rings?

Oh, and the other question is, do I remove (and not re-use) the original Volvo strut boots/tubes--use only the new boots already on the bilsteins?

Thanks again--the help is appreciated!

Steve A-






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New One last bilstein question (well, maybe two . . .)
posted by  anderssj subscriber  on Tue Jan 10 11:16 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.