Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B21FT very high idle (2500rpm) when O2 sensor connected, 900rpm when disconnected?? 200

So yesterday I decide to clean the throttle body and adjust the linkage on the throttle beacuse off idle response has been terrible and the throttle plate wasn't vertical when the pedal was all the way down.

I also had to adjust the throttle position switch so that it would "click" as soon as the throttle was lifted off idle.

When I put everything back together the car will idle roughly at around 900rpm with the O2 sensor disconnected, but when connected the idle climbs to about 2500rpm.

I thought it was an air or vacuum leak at first, so I double checked everything and that wasn't the case, even the inside guage shows a strong vacuum.

The idle adjustment screw is backed off so that the throttle plate is totally closed on idle, so there must be a reason the idle motor is letting through so much air.

I would appreciate any ideas or suggestions on where to go from here, I'm up at school so I have limited access to tools and books.

Thanks,
--
Zack Silver 83' 242Ti (225k)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B21FT very high idle (2500rpm) when O2 sensor connected, 900rpm when disconnected?? [200]
posted by  kaperz81  on Sat Sep 17 12:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.