Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2018 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Steering Rack Replacement - ZF to Cam 200 1987

posted by  someone claiming to be Stan Lee on  Wed Jun 29 16:30 CST 2005 [RELATED]

Hello all. I'm getting ready to replace my rack (old rack is ZF) with a rebuilt Cam rack. I want to be sure I connect the hoses properly and was wondering if the hose fittings are different for the high pressure and return hoses. If not, which connection on the Cam rack is for the high pressure side? Any other insights to make this job go smoothly would be appreciated. Thanks.








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Steering Rack Replacement - ZF to Cam 200 1987

    posted by  someone claiming to be jim on  Thu Jun 30 17:06 CST 2005 [RELATED]

    The fittings on the hose ends are different sizes. Not sure which is pressure and return but both cam and zf are configured the same way. So large to large, small to small. Can't mess it up cause they'll only fit 1 way.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Steering Rack Replacement - ZF to Cam 200 1987

      posted by  someone claiming to be Stan Lee on  Fri Jul 1 06:13 CST 2005 [RELATED]

      Thanks...much appreciated







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.