Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2022 700 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector seals on a B230 - replaceable? 700

In reading the FAQ's - I find that the source of fumes in the cabin may very well be injector seals.

It is running fine (indicating good injectors) - so should I just replace these seals? Is there any special procedure other than using some silicone grease to help seat them and make it easier to go back together?

Thanks
Andrew in AL
--
'Be blessed in your quest'' 89 764 (110K), '94 940T (180K)








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Found it 700 1989

Think I found my own answer. The kit is 4.50 per cylinder at Groton.

--
'Be blessed in your quest'' 89 764 (110K), '94 940T (180K)








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Found it 700 1989

Be carefull. It's easy to bust otherwise good injector during removal.
They tend to get stuck. Spray some lubricant around the base first,
and wait few minutes. Also, some kits are not compatible.

p.s. Unless I'm 100% sure they are bad, I wouldn't mess with them.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.