Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

80 242 fenders 200

Will the fenders from a 244 fit on a 242? My local u pull it has a bunch of 244's but no 242's. I need the drivers fender. Bob








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    80 242 fenders 200

    They should fit, just be aware of the turn signal differences before pulling the fender. The '86-'93 244/245 cars changed turn signals, not positive but I think a fender up to '85 will fit in all respects.

    Just as a side note, the GT fenders have a slightly different ridge that the trim sits on, I had to purchase a new fender (yep, still make 'em) two years ago after a fender bender.

    Bean
    --
    '80 242GT 93k, '94 945T 149k, '89 765T 71k (new '94 B230FT)








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Bumper trim 200

      Yes- fenders up to '85 will fit, but pulling a fender off a non-"commando" bumper 240 ('82?-'85) would require filling the holes for the above-the-bumper trim and relocating them (about an inch?); also there's an extra hole or two for the plastic bumper cover on the later cars. (I've got an '84 DL fender on my '78 DL.)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.