Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Windshield trim '93 245 200 1993

Good day, Brickboarders,

I have a metal trim (could be aluminum) around my windshield (1993 model 245) which is losing it's black paint. Rather than try and scrape the balance of black paint off, can I remove this trim or does it serve as a windshield retainer.

All advise on how to deal with this issue would be much appreciated.

Thanks
Morton
'93 245
'91 740








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Windshield trim '93 245 200 1993

    is this the trim which touches the window glass on the outside of the vehicle and has a viewable edge of about 1/4"

    --
    big rich in arkansas '62 544 132K, 85 244 227K, 95 855 130K








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Windshield trim '93 245 200 1993

      that part wraps around the windshield edge and has a groove for the seal to hold onto from the inside

      BTW the clip at the bottom of the windhield gasket should stays in place and not slide around, if it does it may cause a leak - a loose or removable clip is an indicator that the previous installer has done the job incorrectly - the part many installers screw up on is that the clip goes in place before the windshield is put into the car
      --
      big rich in arkansas '62 544 132K, 85 244 227K, 95 855 130K







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.