Volvo RWD 120-130 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 1/2003 120-130 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Wheel alignment shims 120-130

G'day All!

Does someone know what the shim size (bolt hole size) the 122 control arms use? I need to purchase a complete set of shims to do my next wheel alignment (There are no shims at all at the moment).


Thanks!
Alex.
--
Alex Shevlin (Sydney): '69 122S, '72 144S, '87 Merc 190D








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Wheel alignment shims 120-130

    They are 7/16"/11mm bolts. 12mm or ½" bolt size would work also, but fit looser.
    The standard ones are kinda long and deep, about an inch wide and maybe
    1 ¼" long
    --
    George Downs Bartlesville, Heart of the USA!








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Wheel alignment shims 120-130

      Alex. Most wheel alignment shims are open elongated slots which can be slipped in or out by just loosening control arm bolts. Any wheel alignment shop will have buckets of them, or go to wreckers and get Holden shims. I assume you have access to wheel alignment equipment. Jack.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.