Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2004 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Did I mess up control arm washers? 900 1993

I replaced the bushings om my 1993 960 with new "harder" rubber ones.
I also got new washers, front and rear.
After the "excitement" of wrestling with the suspension, I now realize that I fitted only the front ones, the rear washer/support seems to have a big flat stop and forms part of the control arm.
I am not sure if I did the job correctly.
I did take the car and got the front end aligned and it seems to be OK.
Although when I look at it now, an "extra" rear washer may fit.

Dan








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    Did I mess up control arm washers? 900 1993

    The 960 up to 1994 front ends are the same as the 940 and most if not all 740s. The earlier versions (year???) of this control arm had a bump stop for the large washer. Later front ends have the large washer welded in place and you do not use the additional washer. Many suppliers just provide the universal kit with both washers. The profile of the welded on washer should look like the one in your hand. If you have just a bump stop then you will have to add the washer.--
    Tom F. Couple of Volvos Mods, RainX & cup holders.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.