Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2001

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

STUBBORN 940 Belt Pulley

I'm having some trouble getting off the belt pulley on the front of the crankshaft of a B230 engine.

I have had them off before on my 240's to replace the timing belt without so much difficulty.

I tried pulling with brute strength and carefully tapping with a hammer. I don't have any wheel pullers.

I'll try putting PB-blaster on it now, any help appreciated.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

STUBBORN 940 Belt Pulley

Thanx, Steve. The crankshaft pulley off now.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

STUBBORN 940 Belt Pulley

Gotta luv PB blaster. It's become one of my best companions.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

STUBBORN 940 Belt Pulley

PBlaster, then tapping around the edge with a mallet, assisted by a piece of wood if needed.
When reinstalling, use antiseize on the shaft.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.