I need to replace the leaking rear cam plug (round). Can someone point me to some instructions. I have tried the search but have come up empty. Does Bently have instructions (Book is at home, but I am not.)

Thanks.

Mark

I did one like Manolo says—just clean the hole and press/lever it in (flat side out). For insurance you can make and install a retainer piece, per Don Foster's photo and dimensions. The tapped holes are already there. Standard 6mm thread, 10mm hex bolts.
--
Bruce Young
'93 940-NA (current) — 240s (one V8) — 140s — 122s — since '63.

http://www.brickboard.com/FAQ/700-900/EngineSealsBeltsVent.htm#LeakingRearSealandReplacementTips
--
90 744ti, Airbox, K/N, Cold air, G-Valve, Dual boost control, VDO, Modified exhaust. 88 745 gle.

When I was in the same postion, I bought a can of carb cleaner, some high temp RTV, and some paper towels. I cleaned the plug and the hole, put RTV on the plug, pressed it in, waited a few hours, and went home. It's still in there.