My '93 960's driver's side window works fine until it gets almost all of the way down ( with the glass about 3 inches above the top of the door panel). It then slows down at the very end. I took the door panel off and it acts like something is binding. The bolts holding the regulator are tight against the door. What should I check next? I'm going to go ahead and lube everything while I have the door panel off.

Thanks,
Dave

i had the same problem on my 94 with both passenger windows.i finally opened up the track that the window slides into and it's been fine for over a year.with the panel off watch for where it slows(with your fingers out of the way).i pulled the window felt out and spread the track slightly with a chisel that was wider than the track and turned it with a wrench.that was my experience.
--
92-965-204k, 94-965-211k, 92-944t-200k, 83-242dl,totaled(8/04), 84-242GLT,totaled(2/03),83-245GLT,retired(03)

Hi Dave:
Try these repair tips from the FAQs:

http://www.brickboard.com/FAQ/700-900/BodyGlass.htm#WindowMotorSlow

Hope that this helps.

Mike
--
Mike Brown Greenville, NC 1996 965 113K 1994 940 135K 1986 244 137K