Volvo RWD S90-V90 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2000 S90-V90 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Dewfpo it's me again S90-V90

posted by  poolman on  Tue Oct 19 13:07 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Dec 26 02:03 CST 2010
[RELATED]

Question, in your read out that you sent me, step 28 says to install white spacer between tensioner/damper and pulley. Curved side up, Shouldn't this be done before pulling the pin in step 27?
Thanks
Poolman








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Dewfpo it's me again S90-V90

    uid 11021's pic
    posted by  dewfpo on  Tue Oct 19 14:41 CST 2004
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Thu Oct 23 18:34 CST 2014
    [RELATED]

    Hi Poolman,

    There's not much room in there, if you can get the spacer in before pulling the pin, go for it. It can't hurt anything. It's just a little easier to do it after puliing the pin on the tensioner. It will 'snap' into place around the shaft.

    DEWFPO
    --
    1998 S90 071,245 and 1995 964 154,100







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.