Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Injection Wiring 200

I have an 87 240 DL that I had to replace rear main oil seal in. HERE is the problem, I put numbers on all 4 electrical connectors for my injectors when removed however, when I finally got the wire harness routed back in it's correct location, the numbers no longer exist.
I now have sluggish acceloration when engine is cold but runs much better when warm. ??? How can you determine what fuel injector wire goes to the correct injector???








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Fuel Injection Wiring 200

    If you disconnected the wires to the temperature sensors and knock sensor you may have swapped two of them over on re-assembly if the connectors are the same.

    Colin.

    1990 740SE B200E/M47, remote C/Locking.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Fuel Injection Wiring 200

    No specific order to the wires. This is not your problem.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Fuel Injection Wiring 200

      Thanks!!
      I was afraid of that.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.