Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2011 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

New Cam Gear install questions 200

posted by  someone claiming to be 240 owner on  Sun Oct 17 04:01 CST 2004 [RELATED]

Just recieved an aftermarket drilled cam gear and I need the correct way of installing it. I installed it using the 4 degree hole and installed it TDC hole. Do I need to rotate the cam 4 degree and line up the TDC and install the timing belt. Need help with this. Thanx








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    New Cam Gear install questions 200

    posted by  rhaire on  Sun Oct 17 09:31 CST 2004
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Mon Aug 4 10:16 CST 2014
    [RELATED]

    I have adjustable ones and the machined set off-set type and as I recall do this. It has a secondary key hole right? About 180 degrees but really 4 degrees off 180? You used the secondary hole, then youu should set the cam and belt as usual using the tdc mark, which is actually 4 degrees advanced. TDC on the crank and the dizzy on its edge mark. That way the cam is 4 ahead of the rest, what you want.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.