Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2013 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

In tank pump plastic cap removal 700 1986

posted by  bags on  Sat Oct 16 09:02 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hi all,
I think that I have a problem with my pump sock or a hole in the line because I have trouble when the fuel tank gets below half full. I have removed all the hoses and the electrical connection from the access hatch in the trunk. It has the large plastic screw top holding everything in place. I don't have a special tool to remove it so I have tried banging it out with a hammer and a block of wood, alls using a strap to try and unthread it. So far not luck, I have gone around and broken the corrosion between the faceplate and the plastic but still can't get the slightest budge.

Should I be using a penetrating oil, silicon spray or solvent like wd40 on this? Does anyone else have some advice on how I can get it off? and the plate is pretty corroded can I get a replacement and how should I order it (don't know what its called of if its a dealer only part. Thanks for the help.
Andrew






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New In tank pump plastic cap removal [700][1986]
posted by  bags  on Sat Oct 16 09:02 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.