Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2011 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

tailshaft/speedo drive Q 200

hi all, 85 244 turbo just installed AW-71 tranny. spedometer not working, spring cable inside sheath not spinning when removed from speedometer. can the gear with teeth inside the tailshaft housing spin freely on the shaft and not turn the plastic gear that plugs into the tailshaft housing? what holds this gear on the shaft? i think that is what is happening but would like to have some input before i remove tailshaft housing (only fun the first time) thanks for any input








  REPLY TO THIS MESSAGE    PRINT   SAVE 

tailshaft/speedo drive Q 200

It could be that the cable rather than the drive gear is broken. Ie. pull on the spring cable and see if it slips out broken.
--
1980 245 Canadian B21A with SU carb and M46 trans








  REPLY TO THIS MESSAGE    PRINT   SAVE 

tailshaft/speedo drive Q 200

hi there, it is not the cable or the drive gear as i replaced them. thanks for the thought.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.