Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2010 900 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

ECT Connector 900 1992

posted by  SF940T on  Sun Oct 3 13:31 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Anyone have a source for an ECT connector. Mines is loose and moves causing occasional hot start problems. I would like to replace the entire connector and wiring up to the ECU connector.








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    ECT Connector 900 1992

    posted by  spook on  Sun Oct 3 14:35 CST 2004
    Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
    last visit: Fri Oct 24 08:06 CST 2014
    [RELATED]

    Dear SF940T,

    May this find you well. I think a salvage yard is your best bet, if you can find a car with that section of the harness.

    If you have to splice the wires, I'd recommend soldering them (with rosin core solder, the only type suitable for electrical connections).

    Before completing the splice, I'd put shrink tubing onto the wire. I'd then coat the splice with dielectric grease and would then position the shrink tube, such that it extended 3" in either direction past the splice. Once the shrink tube is heated and shrinks, it will form a water tight seal.

    Hope this helps you get your brick back to normal.

    Yours faithfully,

    spook







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.