Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

1-2-3 code for coolant temp sensor 200 1990

When check engine light comes on car starts idling rough and this is only code given.

Replaced sensor and code still came back. The sensor for ECU not temp gauge. Maybe problem in wire harness?








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    1-2-3 code for coolant temp sensor 200 1990

    From the Volvo manual:

    "If the signal from the ECT sensor corresponds to a temperature below -40C (-40F) or over 120C (240F) a DTC is logged."

    "Causes of fault:
    Break in or grouding of wiring, connections or a component.
    Contact resistance in connections.
    Poor signal GND connection."

    EE2 - Checking the reference voltage
    - Ignition on
    - Disconnect the sensor
    Connect a voltmeter between terminal 1 on the connnector and GND. The voltmeter should read 5V.

    EE3 - Checking the ECT sensor resistance
    - Ignition off
    - Sensor disconnected
    Connect an ohmmeter between terminal 1 on the sensor and GND. The (resistance) should read

    (from graph) 20C ~2600ohms, 100C ~200 ohms, 0C ~6k ohms

    ---

    The wire ends up on the ECU at pin 13.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.