Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 1800 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Injector O-rings and Washers Musings 1800 1970

Got all new seals for my injectors. Noted some interesting things.
2 of the holder o-rings were cracked. All were very brittle and flattened. They didn't even look like o-rings, but more like washers. All the holders were very grimy on the inside. Also, there were no fiber washers. So, after all new o-rings, started up, and didn't run as rough or die during warmup. Could it be possible that I had some air leaking past the holder o-rings, causing the roughness?

What's the purpose of fiber washers? Do they aid in sealing? FYI, there a 2 fiber washers. One goes between the injector holder and the head. The other goes between the metal washer and the holder. (My metal washer was still there)

Tom








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Injector O-rings and Washers Musings 1800 1970

The fiber washers prevent heat transfer to the injectors thus preventing vapor lock.
Thad








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Injector O-rings and Washers Musings 1800 1970

Could it be possible that I had some air leaking past the holder o-rings, causing the roughness?

Yes.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.