Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2014 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Cruise Control 200

I have a 1990 SW (240) with working cruise control that I am preparing to sell. I'm going to pull the cruise control off it and install it in my 1991 240 sedan which has none. In the event you have worked on or done this dose anyone have any info/tips about this Volvo project for me.

TIA








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    Cruise Control 200

    This is the easiest system to transfer and definitely worth doing. Both cars are wired for cruise. You will have to remove:
    vacuum pump in engine bay, unplug harness, leave harness
    vacuum hose, pump to pedal switches
    pedal switches (remove from bracket, you have a bracket in the 92)
    acuator bellows, 1 13 mm nut
    unsnap accelerator linkage piece
    ECU, screwed to cruise bracket above steering column
    harness from ECU to stalk and to main cluster harness
    ts/cruise stalk








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Cruise Control 200

      I pulled the panels and looked under the dash and hood, I have ID'd everything you mentioned except the ECU?








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      Cruise Control 200

      Thank You Very Much, this is the info I hoped for!







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.