Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

ICU Connector Sleeves 200

1988 240GL 230BF

I've been having intermittent ignition problems, and I've isolated the problem to the connection at the ICU. I've purchased the sleeves that Volvo put out to correct this frequent problem.

How do I install the sleeves to the connector pins on the ECU? Do they go slide all the way to the base of the pins, or should I just keep them on the tip of the pin?

Thanks in Advance!








  •   REPLY TO THIS MESSAGE    PRINT   SAVE 

    ICU Connector Sleeves 200

    I put them just below the tips of the pins on my CU. I just used a punch to put them on








    •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

      ICU Connector Sleeves 200

      OK, thanks. I got a sleeve on just fine, but it pushed the female part of the connection back into the harness connector. Did I do something wrong? Now what?

      Thanks again, Dan in AZ.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.